Outdoor Water Solutions WTW0114 Guide d'installation Page 16

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 19
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 15
Page 15 Outdoor Water Solutions, Inc.
Installation Manual 2/12 (Feb. 2012)
OWS Windmill Head Pivot Bearing
Our new Windmill Head Pivot Bearing allows the windmill head to turn much easier. This is ideal
for areas of low wind or areas where you might be closer to tree’s or building’s than recom-
mended. This item now comes standard on all wooden windmills.
Head Pivot Bearing. This sits on top
of the windmill cone. Make sure the
rotating collar is on top!
2. Slide the Pivot Tube Washer onto the pivot tube (Do Not Grease). Then slide the Windmill
Head Pivot Bearing onto the pivot tube shaft. Make sure the rotating collar is on top and the
fixed bearing plate is on the bottom. Slide the pivot tube and compressor into the windmill
bushings.
Pivot tube washer – DO
NOT grease the washer!
3. After the completed rotor head unit has been mounted at the top of the tower, insert the air
line up through the tower (starting at the bottom and going out the top of the pivot tube). Put
a small amount of grease onto each end of the ½” x ½” ninety-degree hose barb. Connect one
end of the ninety-degree hose barb to the line running down the tower and to the pond. Push
the air line back down and insert the ninety-degree hose barb through the
9
16” hole in the pivot
tube and into the ½” air line connecting the compressor (see Illustration 8). A long-handled
screwdriver or wrench can help leverage the hose barb into the ½” connecting hose.
4. Insert the hose into the elongated hose bracket and air line clamp that was attached to the tower,
just below the cone in the top 4’ section. Tighten to secure the air line in the clamp. This allows
the air line to spin on the hose barb and prevents kinking of the hose when the head spins.
5. Install the dome (DOME) on the outside of the blade hub assembly (HUB). Secure with the four
#10 x ½” sheet-metal screws (package G) to blade hub assembly (HUB).
90-DEGREE ELBOW FITTING
½” CONNECTING HOSE (INCLUDED)
½” HOSE
Illustration 8
Vue de la page 15
1 2 ... 11 12 13 14 15 16 17 18 19

Commentaires sur ces manuels

Pas de commentaire